Brake fluid tester
Brake fluid tester with clamps, set
BRKFLUDTEST-EL-(DOT3-5)
Register now and access more than 125,000 products
- For all standard brake fluids (DOT3, DOT4, DOT4+, DOT5.1 etc.) and new brake fluids
- Operated through vehicle's own 12 V battery
- Measuring temperature up to +320°C via boiling point process
- Very simple user guidance through full test process on the LCD display
- Polarity protected
The brake fluid should be replaced at least every two years or if the fluid is approaching the wet boiling point!
Notes on use: Clean test tip with water after use
Datasheets(X)
The absorption of water (hygroscopy) lowers the boiling point of the brake fluid. Long braking operations may cause steam bubbles to form and could result in failure of the braking effect. The most accurate way to monitor the boiling point of the brake fluid is to use our boiling point tester. The brake fluid should be changed if the boiling point is below the recommended minimum temperature.
Last viewed
Methyl methacrylate adhesive MAK 38
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 8.8, zinc-plated, blue passivated (A2K)
Paint mixing cup
Battery-powered hammer drill H 18-MA
1/2 inch torque wrench, limited edition
Window seal
Klebfix superglue
Hex head screw with thread up to head ISO 4017, A2-70 stainless steel, plain
Hose clamp with asymmetrical lock
Hex head screw with shank ISO 4014, steel 8.8, zinc-plated, blue passivated (A2K)