Combination filling appliance
Combination filling appliance
FILR-LUB-COMBI-F.GREASE-25KG
Register now and access more than 125,000 products
Suitable for filling:
- Lube-Shuttle system cartridges in conjunction with a refill adapter
- Hand-lever grease guns
- Single-handed guns
- Lubricating units with filling nipple in accordance with DIN 1283
Commercially available greases up to NLGI Class 2 can be used. We expressly exclude any other use.
Lube-Shuttle® is a registered trademark of MATO GmbH & Co KG.
Datasheets(X)
The combination filling appliance is suitable for filling Lube-Shuttle® system cartridges in conjunction with a refill adapter, hand-lever guns, single-handed guns and lubricating units that are equipped with a filling nipple in accordance with DIN 1283, with commercially available greases up to NLGI Class 2.
- Open the grease container and press the grease sequence piston firmly onto the grease.
- Place the centring cover onto the grease container.
- Loosen all 3 thumb screws and slide the centring slide inwards (towards the centre).
- Using the bolts, push the retaining claws outwards as far as they will go.
- Then place the centring cap onto the grease container so that the retaining claws are outside
- and the centring slides are inside the grease container.
- Push the centring slides outwards using the thumb screw as far as they will go. (Lid centres
- itself automatically on the grease container)
- Hold the thumb screw pressing outwards and slide the retaining claw inwards as far as it will go
- using the bolt. Tighten the thumb screw securely.
- Secure the remaining 2 thumb screws and bolts as described above.
- CAUTION!! Check that the centring cap is firmly seated on the grease container.
- The pump can now be pushed through the clamp and secured by means of clamping
- screws.
- The combination filling device is now ready for use.
- Press the lubrication device with the filling nipple onto the filling nozzle of the filling device. The filling nozzle has
- a lock valve.
- The grease automatically pushes back the sealing sleeve in the grease container during the filling process. The
- piston rod of the grease container must be inserted fully before filling. When increased
- resistance is felt at the hand lever of the filling device, the filling process is finished.
Material | Steel |
Material of piston | Brass |
Material of gasket | Nitrile butadiene rubber (NBR) |
Suitable for inner diameter of grease bucket | 300-335 mm |
Lid diameter | 365 mm |
Height | 535 mm |
Product weight (per item) | 5380 g |
Included in delivery | Scope of delivery: pump unit with filling nozzle for filling nipples according to DIN 1283, centring cover, grease sequence piston |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Pneumatic chipping hammer DMH 10
Nitrogen pressure reducer
Tool assortment TOOLsystem equipped
Paint finish assortment 113 pcs in system case 8.4.2
Storage box (empty)
1/2 inch socket wrench insert metric, hexagon, short
Screwdriver, t-handle assortment/set
Angle grinder EWS 8-115 Light
Metal valve 90MS9.7/ 30-27
Impact wrench, pneumatic, access.